Contact Us

Yaode Technology (Shenzhen) Co.,Ltd

Address: 6D1-17, The sixth Floor, The building 203, Tairan Technopark, Tairan Four Street, Tian'an Community, Shatou Street, Futian Zone, Shenzhen City, Guangdong, China

Tel: +86-769-85378226

M/P: +8613825767293

E-mail: yaodepcb@163.com

Drill Maintenance Skills

- Nov 20, 2018 -

All kinds of machines have a running-in period. As long as they are normal operations, they can quickly enter the correct state. If there is a small problem in the drilling machine, you can do it yourself. Here are some common ones. Solution.


Punch problem. If the punch does not come up, it is very likely that there is a problem with the air pressure setting, just re-commissioning. You can also try to raise the punch to 0.5MM, which basically solves the problem of the punch.


There is a burr on it. This is also a common phenomenon. Try to increase the air pressure, or see if the drilling machine and the knife cutting are synchronized. If there is no problem in these two aspects, you need to find the manufacturer's maintenance personnel to help.


The plastic bag is broken. If there is a plastic bag being pulled when punching, it is not only to check the air pressure and air volume of the drilling machine, but also to consider whether there is a problem with the cylinder. At this time, it is necessary to find someone to repair and avoid causing damage. Further impact.


Related News

Related Products

  • Deburring Machine with Abrasive Belt
  • DEC-833 Automatic Grinding Machine
  • Round Corner Machine
  • Vacuum Cleaner
  • Four Knife V-Cut Machine
  • Pneumatic Screen Stretching System